Accu-Lite Mounts 30 mm

Each pair of Element Accu-Lite rings is machined from a single block of 7075-T6 aluminium, which has a higher strength-to-weight ratio than almost any other alloy. This block is machined to the tightest tolerances to ensure a smooth and precise mating surface between the scope body tube and base. Add to this a stainless steel cross-bolt, clamp and base nut, and you have one of the most accurate and reliable ring sets on the market.

A good ring set is of paramount importance, as it is the only connection point between the rifle and the scope. We are confident that the Accu-Lite will provide you with a lifetime of reliable service, giving you peace of mind even in the most difficult shooting environments.

For the best possible results, you should follow the torque guidelines on the following page, as over-tightening the rings may cause temporary or permanent damage to the scope's body tube and internal components. 

Specifications:

30 L

Height: 22 mm

Weight: 113 g

Material: 7075-T6 Aluminium and Steel

Mounts on: Piccatinny and Weaver

Max Torque rings: 25 in-lbs (2.8 nm)

Max Torque base: 60 in-lbs (7.7 nm)

30 M

Height: 25 mm

Weight: 123 g

Material: 7075-T6 Aluminium and Steel

Mounts on: Piccatinny and weavers

Max Torque rings: 25 in-lbs (2.8 nm)

Max Torque base: 60 in-lbs (7.7 nm)

30 H

Height: 29 mm

Weight: 137 g

Material: 7075-T6 Aluminium and Steel

Mounts on: Piccatinny and Weavers

Max Torque rings: 25 in-lbs (2.8 nm)

Max Torque base: 60 in-lbs (7.7 nm)

Paypal payments read carefully.

The new Paypal rules do not provide for refunds of transaction fees.

Paypal retains all commissions from our company, consequently all refunds will be reduced by 5%.

No complaints will be accepted.